To completely turn off your 3D pen, you need to unplug it from the power source.
Many 3D pens, like the one referenced, have a built-in safety feature that puts them into an inactive state and begins cooling down after a period of disuse. The reference specifically mentions that "After 2 minutes of inactivity, [the pen] will begin to cool down."
However, for a full shutdown, simply waiting for the cool-down period isn't enough. The ultimate step to ensure the device is completely powered off and safe is to disconnect it from the electricity.
Steps to Power Down Your 3D Pen
Properly shutting down your 3D pen involves a couple of stages:
- Inactivity Mode: Allow the pen to sit idle for the specified period (e.g., 2 minutes as mentioned in the reference). This triggers an automatic cool-down process.
- Complete Shutdown: Unplug the power adapter from the pen or the wall outlet. This action entirely cuts off the electrical supply, ensuring the pen is fully turned off.
Important Note: The reference also brings up the question of removing filament before unplugging ("But wait you may be wondering. Should I remove the filament first."). While the provided clip doesn't answer this specific question, proper shutdown procedures often involve removing or trimming the filament to prevent clogs upon the next use. Consult your pen's specific manual for the recommended filament handling procedure during shutdown.
Summary Table
| Stage | Action | Purpose |
|---|---|---|
| Inactivity | Wait for idle time | Triggers automatic cool-down |
| Complete Off | Unplug the power source | Cuts off all power for full shutdown safety |
By following these steps, you can ensure your 3D pen is safely and completely turned off after use.
