To set zones on a DSC alarm system, you need to assign keypad zones within the system's programming. Here's how:
-
Enroll Keypads: First, ensure all installed keypads are enrolled into the desired slots. This is done using programming section [902] (Add/Remove Modules). This step is crucial because you need to define which keypad will be used to control which zones.
-
Assign Keypad Zones: Access the keypad zone assignment sections. This is done by entering programming sections [861] through [892]. These sections correspond to keypads 1 through 16 respectively.
-
Enter Subsection 011: Within each of the keypad programming sections ([861]-[892]), you'll need to access subsection 011. This subsection is specifically for assigning zones to that particular keypad.
-
Enter 3-Digit Zone Numbers: In subsection 011, enter a 3-digit zone number for each keypad zone that you want to assign. For example, if you want keypad 1 to control zones 001, 002 and 003, you would go to programming section [861], subsection 011, and enter "001", "002", "003" in the available slots. The number of zones you can assign per keypad depends on the DSC model, consult your system's manual.
Example:
Let's say you want to assign zones 005, 006, and 007 to Keypad 3. You would perform the following steps:
- Enter programming mode on your DSC panel (refer to your manual for how to enter programming mode, often involving an installer code).
- Enter programming section [863] (for Keypad 3).
- Enter subsection 011.
- Enter the zone numbers "005", "006", and "007" sequentially.
Important Considerations:
- Refer to your DSC alarm system's installation and programming manual for specific instructions and details relevant to your model.
- The exact programming codes and procedures can vary depending on the specific DSC model you have.
- Incorrect programming can lead to system malfunctions. If you're unsure about any step, consult a qualified alarm technician.
In summary, setting zones on a DSC alarm involves enrolling keypads, accessing specific programming sections, and assigning 3-digit zone numbers to each keypad zone, following the guidelines in your system's manual.
