To install a new oil filter, you'll need to remove the old one, prepare the new filter, and then properly tighten the new filter onto your engine. Here's a step-by-step guide based on the provided video snippet:
-
Remove the Old Filter (implied): This wasn't explicitly stated but is the necessary first step. Use an oil filter wrench to loosen and remove the old oil filter. Be prepared for some oil to spill.
-
Prepare the New Filter:
- Lubricate the Gasket: Lightly coat the rubber gasket on the new oil filter with fresh engine oil. This helps ensure a good seal and prevents the gasket from sticking to the engine.
-
Install the New Filter:
- Screw onto the Engine: Carefully screw the new oil filter onto the engine by hand. Make sure it's properly aligned with the threads.
- Hand Tighten: Tighten the filter by hand until the gasket makes contact with the engine. Then, tighten it an additional 3/4 to 1 full turn. Follow manufacturer's guidelines if available on the filter itself.
- Final Tightening (with Wrench - Use Caution): If necessary, use an oil filter wrench to tighten the filter a bit more, but be careful not to overtighten it. Overtightening can damage the filter or the engine. The video cautions against overtightening.
Remember to always consult your vehicle's owner's manual for specific instructions and torque specifications for your make and model. It's also advisable to double-check for leaks after starting the engine.
