Using Super Clean on carpet involves a process of application, agitation, and removal to lift stains and dirt. Here's a step-by-step guide:
-
Pre-Clean: Scrape away or vacuum any loose dirt and debris from the affected area of the carpet. This initial step helps Super Clean target the stain directly.
-
Wet the Area: Lightly spray the soiled area with water. This prepares the carpet fibers for the Super Clean application.
-
Apply Super Clean: Spray the pre-wetted area with Super Clean. Use approximately the same amount of Super Clean as you did water. Avoid oversaturating the carpet.
-
Wait: Allow Super Clean to dwell on the stain for 3-5 minutes. This dwell time allows the solution to penetrate and begin breaking down the stain.
-
Agitate: Use a stiff-bristled brush to gently scrub and loosen the soil for about a minute. Be careful not to damage the carpet fibers by scrubbing too aggressively.
-
Rinse: Spray the area again with water to rinse away the Super Clean and lifted soil.
-
Extract Moisture: Blot the area thoroughly with paper towels or, ideally, use a wet/dry shop vacuum to extract as much moisture as possible. This prevents water stains and helps the carpet dry faster.
Important Considerations:
- Test First: Before applying Super Clean to a large or visible area, always test it in an inconspicuous spot to ensure it doesn't discolor or damage the carpet.
- Ventilation: Ensure adequate ventilation when using Super Clean.
- Dilution: While the instructions don't explicitly mention dilution, for delicate carpets, consider diluting Super Clean with water before applying. This can help prevent damage.
- Safety: Wear gloves to protect your hands and avoid direct contact with skin and eyes.
By following these steps carefully, you can effectively use Super Clean to remove stains and refresh your carpets.
