Setting up your ResMed AirSense 10 CPAP machine involves a few simple steps to ensure it's ready for use. After placing the device in a stable location, you will connect the necessary components and attach your mask before starting therapy.
Getting Started: Initial Setup Steps
Proper setup is crucial for effective and comfortable sleep therapy. Here's a breakdown of the typical steps involved in preparing your AirSense 10 device:
1. Place the Device
Choose a stable surface near your bed where you can place the AirSense 10 machine. Ensure it's at a level lower than your sleeping position to allow excess water from the humidifier to drain back into the tub and prevent it from entering the tubing or mask.
2. Connect Power
- Plug the power cord into the power inlet on the back of the device.
- Plug the other end of the power cord into a wall outlet. The device should power on and the screen will light up.
3. Fill the Humidifier Tub (Optional but Recommended)
The AirSense 10 has a built-in heated humidifier.
- Open the humidifier tub.
- Fill the tub with distilled water up to the maximum fill line.
- Close the tub securely and reinsert it into the side of the device.
4. Connect Air Tubing
- Connect one end of the air tubing firmly to the air outlet connector on the back of the device.
- If using a heated tube (like the ClimateLineAir™), align the connector carefully and push until it clicks into place.
5. Attach Your Mask
This is a critical step before starting therapy. As highlighted in the reference, after placing the device, the next step is to "toucher masker" (attach your mask).
- Connect the other end of the air tubing to your CPAP mask.
- Fit the mask onto your face according to the specific mask instructions, ensuring a comfortable but secure seal.
Ready to Start Therapy
Once the device is placed, the tubing connected, and your mask is attached, your ResMed AirSense 10 is essentially ready for use. All that's left to do is press the start button.
- Press Start: Locate the large 'Start/Stop' button (often prominently lit) on top of the device and press it. The machine will begin delivering air therapy at your prescribed pressure settings.
You can then lie down and breathe normally as the device works. Enjoy a great night's sleep!
Before Your First Use
It's always recommended to familiarize yourself with your specific mask fitting instructions and the features available on your AirSense 10 device screen. Your healthcare provider or equipment supplier should provide detailed guidance tailored to your prescription and equipment.
By following these steps, you can successfully set up your ResMed AirSense 10 machine and begin your CPAP therapy journey.
