Installing door stop moulding is a relatively simple task that helps ensure your door closes properly, seals against drafts, and prevents it from swinging through the frame. Based on the provided reference, the process involves carefully positioning and securing the moulding pieces around the door frame.
Here's a general overview of the process, incorporating insights from the reference:
Begin by cutting your door stop moulding pieces to the required lengths for the top and sides of the door frame.
Key Steps for Installing Door Stop
The installation typically involves starting with the top piece, then moving to the sides.
Step 1: Position the Top Stop
- Take the cut piece for the top of the door frame.
- Press gently to position it against the door jamb.
- Ensure it is aligned correctly, typically set back slightly from the front edge of the jamb.
- Nail it into place using finish nails, spacing them appropriately.
Step 2: Install the Strike Side Stop
- Next, work on the strike side of the door jamb (where the door latch engages).
- Take the cut piece for this side.
- Line it up with the top piece to ensure a clean mitered joint (if applicable) or butt joint.
- Close the door to position the stop correctly. The reference mentions doing this so the "Locking gauges," which means ensuring the stop is positioned so the door latch and lock mechanism function smoothly when the door is closed against the stop. There should be a slight gap between the door face and the stop when closed to allow the door to latch.
- Once correctly positioned relative to the closed door, press gently and nail it into place.
Step 3: Install the Hinge Side Stop
- Install the piece for the hinge side of the door frame.
- Similar to the strike side, close the door to help position this piece correctly.
- Align the piece with the top stop and ensure it sits properly against the jamb when the door is closed.
- Press gently and nail it into place.
Finishing Touches
- Check that all pieces are securely fastened and the door closes smoothly against the stops.
- Fill nail holes with wood filler.
- Sand the filled areas smooth.
- Paint or stain the door stop moulding to match the door frame or trim.
Here's a simple table outlining the sequence:
| Step | Action | Note |
|---|---|---|
| 1: Top Piece | Position gently, nail in place. | Often the first piece installed. |
| 2: Strike Side | Line up with top, close door to position, nail in place. | Position for proper latching/locking. |
| 3: Hinge Side | Line up with top, close door to position, nail in place. | Position to allow door to close fully. |
| 4: Finishing | Fill holes, sand, paint/stain. | Completes the installation and improves appearance. |
Proper installation ensures your door functions correctly and enhances the finished look of your doorway.
