Wiring a Ring Doorbell involves several steps to ensure proper installation and functionality. Here's a guide based on provided instructions:
Step-by-Step Ring Doorbell Wiring Guide
This process focuses on a wired installation, utilizing your existing doorbell wiring.
-
Turn Off Power: Before you start, turn off the power to your doorbell circuit at the circuit breaker to prevent electrical shock. This is crucial for your safety.
-
Prepare the Jumper Cable: Locate the included Jumper Cable. This cable is necessary to bypass your existing chime if it's not compatible with the Ring Doorbell.
-
Loosen Terminal Screws: At your existing doorbell chime, loosen the screws on the "Front" and "Trans" terminals. Do not remove them completely, just enough to fit the jumper cable.
-
Connect the Jumper Cable: Connect one end of the Jumper Cable to the "Front" terminal and the other end to the "Trans" terminal. This will complete the circuit, bypassing the chime.
-
Remove the Doorbell Faceplate: Carefully remove the faceplate of your old doorbell to expose the wiring.
-
Mark Screw Holes: Mark the screw holes on your wall, using the Ring Doorbell mounting bracket as a template.
-
Install Anchors (Optional): If you are not screwing into wood or need extra support, install the anchors provided.
-
Connect Doorbell Wires: Connect the wires coming from your wall to the appropriate screws on the back of the Ring Doorbell. Usually, this involves connecting the two wires, without specific polarity matters for this type of device.
- Note: The specific steps might have minor variations depending on your particular Ring Doorbell model. Refer to the manual that came with your device for any model specific information.
Summary
The process primarily involves disabling power, bypassing the chime using a jumper cable, mounting the Ring Doorbell, and properly connecting the existing doorbell wires. Always double-check all connections and wiring to ensure everything is secure before restoring power.
