Installing an externally routed dropper post involves a few key steps to ensure proper functionality and a clean setup. Based on the reference video "How to Install Externally Routed Coast Dropper Post with Puget 2x Lever," here’s a general guide:
Steps to Install an Externally Routed Dropper Post
While a complete step-by-step is unavailable from the reference, we can infer key aspects and supplement with common practices for installing externally routed dropper posts.
-
Saddle Rail Positioning: Ensure both saddle rails are securely positioned in the round grooves located on the top and bottom portions of the saddle clamp. This is crucial for a stable and safe setup.
-
Routing the Cable:
- External Routing: Because the dropper post is externally routed, the cable housing will run along the outside of your bike's frame.
- Cleanliness is Key: Plan the cable route carefully to avoid obstructions and ensure smooth activation. Use zip ties or cable guides to secure the housing to the frame.
- Housing Length: Ensure you have enough cable housing to allow for full suspension travel and handlebar movement without kinking or pulling.
-
Lever Installation & Cable Tension:
- Lever Placement: Mount the remote lever on your handlebars in a comfortable and accessible position. The reference mentions a "Puget 2x Lever," indicating a specific type of lever.
- Cable Connection: Connect the cable to both the dropper post actuator and the remote lever.
- Adjust Cable Tension: Fine-tune the cable tension so the dropper post activates smoothly and returns fully. Too little tension, and it won't activate. Too much, and it might stay partially activated.
General Tips for Dropper Post Installation
- Read the Manual: Always consult the manufacturer's instructions for your specific dropper post model.
- Use the Right Tools: Have the necessary tools handy, such as Allen wrenches, cable cutters, and zip ties.
- Test Thoroughly: After installation, cycle the dropper post multiple times to ensure it's working correctly.
- Check for Interference: Make sure the cable housing isn’t interfering with any other bike components.
