To properly use uni foam filter oil, you need to thoroughly coat the foam filter and then remove any excess oil. Here's a step-by-step guide:
Applying Uni Foam Filter Oil
Step 1: Initial Coating
-
Spray: Using UFF-100/104 Aerosol Filter Oil, spray the filter both inside and outside. Make sure you spray it evenly until the entire filter is covered with oil.
- This ensures that all the foam is treated for maximum effectiveness.
-
Example: Imagine a sponge; you want to saturate all parts of it with the oil, not just the surface.
Step 2: Work the Oil In
- Massage: Use your hands to work the oil into the foam. Ensure the oil penetrates all parts of the filter, reaching the core of the foam structure.
- This step helps to properly distribute the oil.
Step 3: Second Coating
- Repeat: Spray the filter again, inside and out, until the filter has complete coverage. This ensures thorough saturation.
- Work Again: Work the oil into the foam using your hands.
Step 4: Remove Excess Oil
- Dab: Use paper towels to dab the filter, removing any excess oil. This is important as too much oil can restrict airflow.
- Dabbing prevents the oil from pooling and clogging the filter.
Summary of Steps
| Step | Action |
|---|---|
| Step 1 | Spray the filter inside and out |
| Step 2 | Work the oil into the foam |
| Step 3 | Repeat the spraying and working process |
| Step 4 | Dab filter to remove excess oil |
By following these steps, you will ensure your uni foam filter is properly oiled and ready for use. This improves the filter's ability to trap dirt and debris, ultimately protecting your engine.
