To change a VonZipper goggle lens, you primarily focus on carefully detaching the old lens from the frame—a process often indicated by an audible "pop"—and then securely inserting the new lens, followed by a quick clean to ensure optimal vision.
Changing your goggle lens is a straightforward process when done carefully, ensuring you maintain the integrity of both the frame and the new lens.
1. Lens Removal
The first step involves disengaging the existing lens from the goggle frame.
- Grip the Frame Firmly: Hold your VonZipper goggle frame securely with both hands. It's often best to hold it by the nose bridge and one of the sides.
- Apply Gentle Pressure for Release: To release the lens, you need to carefully apply pressure around its edges where it inserts into the frame. Move your fingers all around the perimeter of the lens, gently pulling the frame away from the lens or pushing the lens outward from the inside. As the lens disengages from its groove, you will hear that pop. This audible cue confirms that the lens is successfully releasing from the VonZipper frame's retention system.
2. Lens Insertion
Once the old lens is removed, you can proceed to install your new VonZipper replacement lens.
- Align the New Lens: Carefully take your new lens, handling it only by its edges to avoid smudges or scratches on the viewing surface. Align the new lens with the corresponding grooves and slots in the goggle frame.
- Secure into Frame: Start by inserting one corner or a specific tab of the lens into its designated slot. Then, systematically work your way around the frame, gently pressing the lens into place. Ensure that the entire edge of the lens snaps securely into the frame's groove all the way around. You might hear small clicks as it seats fully. Verify that there are no gaps between the lens and the frame, ensuring a complete seal.
3. Post-Installation Cleaning
After the lens is successfully installed, a final clean-up is essential for clear vision.
- Wipe Off Fingerprints: It's common to leave fingerprints or smudges during the lens changing process. Use a clean, soft microfiber cloth and wipe off the fingerprints from both the inside and outside surfaces of your newly installed lens. This ensures crystal-clear vision without any distractions. And you're all set! Your VonZipper goggles are now ready for action with their new lens.
Important Tips for Lens Changing
- Handle with Care: Always handle goggle lenses by their edges to prevent scratching or smudging the optical surface.
- Work in a Clean Environment: Perform lens changes in a clean, dust-free area to prevent debris from getting trapped between the lens and the frame or clinging to the lens surface.
- Check the Seal: After installation, visually inspect the goggle to ensure the lens is seated perfectly flush all around the frame. A good seal is crucial for preventing fogging and protecting your eyes from elements.
- Store Spare Lenses Safely: Keep your spare or old lenses in a protective pouch or case to prevent damage when not in use.
