To use Walker Tape glue, such as Ultra Hold Adhesive, you typically apply an even layer to the scalp, blow dry it until it becomes tacky, repeat this process, and then press the hair system onto the prepared area, holding it firmly in place.
Understanding the correct application method is crucial for achieving a secure and long-lasting hold with hair system adhesives like those from Walker Tape. While specific instructions may vary slightly between products, a common approach involves preparing both the scalp and the hair system, applying the adhesive in layers, allowing it to reach the proper tackiness, and then carefully attaching the system.
Step-by-Step Application (Based on Ultra Hold Adhesive Reference)
Based on the referenced guide for Ultra Hold Adhesive, the application process involves careful layering and drying:
- Prepare the Scalp: Ensure the scalp is clean, dry, and free of oils or residues. This creates the best surface for the adhesive to bond.
- Apply the First Coat: Apply an even coat of Ultra Hold to your client's scalp. Use a brush or applicator tool designed for adhesive application to ensure smooth, uniform coverage over the desired area.
- Blow Dry: Blow dry the applied adhesive until it is tacky to the touch. This allows the solvents in the adhesive to evaporate, leaving behind a sticky surface ready for the next layer.
- Repeat Application: Repeat these steps one more time. Apply a second even coat of Ultra Hold over the first layer on the scalp and blow dry until it is tacky again. Applying multiple thin layers and drying thoroughly is often recommended for maximum hold and durability.
- Attach the Hair System: Carefully press the hair system onto your client's scalp where the adhesive has been applied. Start at the front edge or back edge, aligning the system correctly before pressing down the rest.
- Secure the Hold: Hold the hair system in place firmly for several seconds to allow the adhesive to bond securely to both the scalp and the base of the hair system. Applying gentle, even pressure across the entire area helps create a strong attachment.
Key Considerations for Application
- Cleanliness: A clean scalp is paramount. Use scalp preparation products recommended by Walker Tape or your hair system professional.
- Thin, Even Coats: Applying thin layers is better than one thick layer. It allows the adhesive to dry properly and cure effectively.
- Tackiness is Key: Do not apply the system until the adhesive is sufficiently tacky. Applying too soon can result in a weaker bond and messy application.
- Firm Pressure: Applying adequate pressure helps the adhesive grab onto the hair system base and the scalp effectively.
By following these steps, you can achieve a reliable hold using Walker Tape adhesives like Ultra Hold, ensuring your hair system stays secure.
