Changing laminator film on the HeatSeal Ultima 65 requires careful handling of the film web and specific machine components.
Changing the laminator film on a HeatSeal Ultima 65 involves a process that includes positioning the film, interacting with machine parts like the heat table, and ensuring safety features are engaged. While the full procedure involves removing old film and threading new rolls, specific steps during the process require careful handling of the film web.
Key Steps Based on Reference
According to information regarding the process, part of changing the film involves handling the film web around the heat table. These steps are crucial for properly positioning the film before lamination can begin.
Here are actions highlighted as part of the film changing procedure:
- Position and Pull Film: You need to correctly position and pull the top piece of film down.
- Grab Top and Bottom Film: Securely grab the film from both the top and the bottom sections.
- Reinstall Heat Table: Reinstall the heat table, ensuring it is correctly positioned under the film web.
- Lower Safety Shield: After handling the film and table, lower the safety shield.
These steps are vital for preparing the film path correctly for the machine to function safely and effectively.
General Film Changing Overview
While the specific steps above detail a part of the process involving the heat table and film web, a complete film change typically includes:
- Removing the used film rolls.
- Loading new rolls of the correct size and type for your Ultima 65.
- Threading the new film web through the machine's path, which includes guiding it around rollers and the heat table.
- Ensuring the film is properly tensioned and aligned.
- Performing a test run to check for proper lamination.
Always consult your machine's official manual for detailed instructions specific to the HeatSeal Ultima 65 model to ensure all steps are followed correctly and safely.
Tips for a Smooth Film Change
- Always power off and unplug the laminator before changing film rolls.
- Handle film rolls carefully to avoid damage or creasing.
- Follow the machine's threading diagram precisely.
- Ensure the film is loaded in the correct orientation (adhesive side facing inward).
- Clean any adhesive residue from rollers during the change if necessary.
By following the necessary steps, including correctly positioning the film and reinstalling components like the heat table as described, you can successfully change the laminator film on your Ultima 65.
