Installing a bathroom sink tap is a manageable DIY project if you follow the correct steps. Here's a guide based on typical procedures:
Steps for Installing a Bathroom Tap
| Step | Description |
|---|---|
| 1 | Turn off the water supply. Locate the shut-off valves under the sink and turn them clockwise until they stop. You may also need to turn off the main water supply for added safety. |
| 2 | Remove the old tap. Disconnect the water supply lines from the existing tap. Unscrew any fixings that secure the tap to the basin. Carefully lift the old tap off the basin. |
| 3 | Fit the connections to your new tap. Attach flexible water hoses and any other necessary parts to your new tap's base. These may vary depending on your tap's design. |
| 4 | Fit the tap to the basin. Place the new tap through the hole(s) in the basin. From underneath the basin, secure it with the provided washers and fixings. Ensure it's firmly in place. |
| 5 | Connect to the water supply. Attach the flexible water hoses from the tap to the corresponding hot and cold supply pipes. Make sure these connections are tight. |
| 6 | Switch the water on. Gradually turn the shut-off valves counterclockwise to restore water flow. Check for any leaks and tighten connections as necessary. |
Things to Remember
- Read the Instructions: Always review the specific installation instructions that came with your new tap.
- Tools: Have the right tools ready, such as an adjustable wrench, basin wrench, and possibly a plumber's tape.
- Leaks: Check carefully for leaks after turning the water back on and tighten any loose connections.
- Seek Professional Help: If you are uncomfortable with any part of the installation, it's always best to call a professional plumber.
By following these steps, you can successfully install a new bathroom sink tap. The reference instructions outline the essential sequence: turn off the water, remove the old tap, fit the new tap connections, secure it to the basin, connect to the water, and then turn the water back on.
