Priming a convertible jet pump is a crucial step before initial startup or after maintenance to ensure the pump is filled with water and can create the necessary suction. This process involves removing air from the pump housing and filling it completely with water.
According to a referenced source, priming a convertible or shallow well jet pump can be done in just a few simple steps:
Steps to Prime Your Jet Pump
Follow these steps to prime your convertible jet pump effectively:
- Remove the screw from the top of the jet pump housing. This screw typically covers the priming port, allowing access to the pump's internal cavity.
- Fill the jet cavity to full capacity with water. Use a funnel or hose to pour clean water into the open priming port until the pump housing is completely full and water stands at the opening.
- Reinstall the cap (or screw). Once the pump is full of water, securely replace the screw or cap you removed in step 1.
After completing these steps, the pump should be ready to start. Priming ensures that the impeller is submerged and the pump can establish prime to draw water from the well or source. Without proper priming, the pump will run dry, which can cause damage.
Remember to always consult your pump's manual for specific instructions and safety precautions, as procedures can vary slightly between models.
