Using ICE Resin involves a few key steps, starting with preparing the resin and hardener for mixing. The video excerpt mentions breaking off the top piece of the resin component with the tip facing away from your face and setting the cap aside (don't throw it away!).
Without more context from the source video, it's difficult to give a comprehensive guide on using ICE Resin. A general outline for using resin would involve:
- Preparation: Gather your materials, including ICE Resin (Part A - resin, Part B - hardener), mixing cups, stir sticks, any embedments you want to include (photos, beads, etc.), and safety gear (gloves, eye protection). Prepare your work surface by covering it to protect against spills.
- Mixing: Carefully measure equal parts of Part A (resin) and Part B (hardener) into a clean mixing cup. The ratio is crucial for proper curing.
- Stirring: Gently stir the mixture for the recommended time (refer to ICE Resin's specific instructions), usually about 2-3 minutes. Scrape the sides and bottom of the cup to ensure thorough mixing. Be careful not to whip the mixture too vigorously, as this can create bubbles.
- Pouring/Application: Carefully pour the resin mixture into your mold or onto your surface. If you're embedding objects, arrange them carefully.
- Bubble Removal: Remove any bubbles that rise to the surface by gently blowing on them, using a heat gun on low setting, or by passing a toothpick over them.
- Curing: Allow the resin to cure undisturbed for the recommended time (usually 24-72 hours), according to the ICE Resin instructions. The ideal curing temperature is usually around room temperature.
- Demolding/Finishing: Once fully cured, carefully remove your piece from the mold. If necessary, sand any rough edges and apply a sealant or polish for a professional finish.
It is essential to always refer to the specific instructions provided with your ICE Resin product, as techniques and curing times can vary.
