To properly use rubber seam tape, especially when dealing with EPDM rubber membrane, follow these steps:
Step-by-Step Guide to Applying Rubber Seam Tape
- Prepare the Surface: Ensure the rubber surfaces you're joining are clean and dry. Any dirt, moisture, or debris can hinder the tape's adhesion.
- Position the Tape: Place the rubber seam tape along the seam where the two pieces of rubber membrane overlap.
- Peel the Plastic Film: Begin to remove the plastic film from the seam tape at a 45-degree angle.
- Bond the Overlapping Rubber: As you peel the film, firmly press the overlapping rubber membrane onto the seam tape.
- Press and Adhere: Use your palm to apply consistent pressure to bond the rubber to the tape as you continue peeling the film. Make sure to follow the length of the seam to ensure proper bonding.
Tips for Successful Application
- Angle Matters: Peeling the film at a 45-degree angle helps prevent bubbles and ensures a smoother application.
- Consistent Pressure: Applying even pressure with your palm will result in a stronger and more effective seal.
- Overlap: Ensure there is sufficient overlap of the rubber membrane onto the tape.
- Cleanliness: Always work on a clean surface to prevent any contamination.
Summary of Instructions
| Step | Action |
|---|---|
| 1 | Prepare the surface |
| 2 | Position the tape |
| 3 | Peel plastic film at a 45° angle |
| 4 | Bond the overlapping rubber |
| 5 | Press and adhere firmly with palm |
By following these steps, you'll achieve a secure and long-lasting seal using rubber seam tape.
