How do I reset my dual band router?

To reset your dual-band router, you can use either the physical reset button or the router's web interface.

Resetting Your Router via the Reset Button

This method is straightforward and usually works for most routers. Here’s how:

1. Locate the Reset Button:
   • The reset button is typically a small, recessed button on the back or bottom of the router.
   • It's often labeled "Reset".
2. Prepare a Tool:
   • You'll need a tool with a thin point to press the reset button. A straightened paperclip or a SIM card ejector tool works well.
   • As stated in the reference video, a "rare and handy tool called a paperclip" can be unfolded to get the "sharp point out" to access the reset switch.
3. Press and Hold:
   • With the router powered on, gently press and hold the reset button with your chosen tool.
   • Hold it for about 10-30 seconds. The router's lights will likely flicker or turn off and on during this process.
4. Release and Wait:
   • Once the lights indicate that the router is restarting, release the reset button.
   • Allow a few minutes for the router to fully reboot. It'll be back to its factory default settings.

Resetting Your Router via the Web Interface

If you can access your router's settings through a web browser, you can also reset it from there.

1. Access the Router's Web Interface:
   • Open a web browser on a device connected to your router's network.
   • Type your router's IP address into the address bar (common addresses are 192.168.1.1 or 192.168.0.1).
   • Log in with your router's username and password (if you haven't changed it, check your router's manual for the default credentials).
2. Locate the Reset Option:
   • In the router's settings, look for an option like "Factory Reset," "Restore Defaults," or similar.
   • This is often found in the "Administration," "System," or "Tools" sections.
3. Initiate the Reset:
   • Click on the reset option.
   • You might be prompted to confirm that you want to reset the router.
4. Wait for Reboot:
   • Allow the router a few minutes to reset and reboot.

Important Considerations:

• Backup Configurations (If Possible): If your router supports it, backup your settings before resetting so that you can restore your customized configuration.
• Default Credentials: After a reset, you'll need to use the default username and password to log back into your router (check your router's manual).
• Reconfiguration: A factory reset will erase all your customizations including WiFi names and passwords so be sure you remember these or configure them again.