To bypass a zone on a First Alert security system, follow these steps: enter your [security code] + [6] + [2-digit zone number]. This will allow you to arm your system while intentionally leaving specific protected areas unarmed.
Bypassing vs. Unbypassing Zones
It's important to understand the difference between bypassing and unbypassing a zone.
| Action | Procedure | Purpose |
|---|---|---|
| Bypass | [Security Code] + [6] + [2-Digit Zone Number] | Temporarily disables a zone, allowing you to arm the system without it. |
| Unbypass | [Security Code] + [1] | Re-enables a previously bypassed zone. |
Steps to Bypass a Zone
Here's a detailed breakdown of how to bypass a zone:
- Identify the Zone: Determine which zone you want to bypass. Each zone corresponds to a specific area or sensor in your home.
- Enter Your Security Code: This is the code you use to arm and disarm your system.
- Enter the Bypass Command: Press '6' on your keypad. This indicates you want to bypass a zone.
- Enter the Two-Digit Zone Number: Enter the two-digit number that corresponds to the zone you're bypassing. For example, if you are bypassing zone 03, enter '03'.
- Listen for Confirmation: Your system should provide confirmation that the zone has been successfully bypassed.
Example
Let's say your security code is '1234' and you want to bypass zone '05'. You would enter the following sequence on your keypad:
1234 + 6 + 05
Unbypassing a Zone
To re-enable a bypassed zone, use the following command:
[Security Code] + [1]
For example, using the security code '1234', you would enter:
1234 + 1
This command will unbypass all currently bypassed zones.
