You can make your turntable spin faster by adjusting the speed screws, typically located under the platter or on the bottom of the device.
For turntables equipped with speed adjustment screws, this is often the most direct method to fine-tune the platter rotation speed. These small screws allow you to slightly modify the calibration of the motor or speed control circuit.
Locating the Speed Adjustment Screws
Finding these screws can vary depending on your turntable's design:
- Under the Platter: On many models, you'll need to remove the mat and the platter itself to access the screws on the top surface of the plinth or motor housing.
- On the Bottom: Some turntables have these adjustment points located on the underside of the unit. You might need to flip the turntable over carefully to find them.
Consulting your turntable's user manual is the best way to pinpoint the exact location of these adjustments for your specific model.
Adjusting the Speed
Once you've located the screws, the adjustment process is straightforward:
- Identify the Correct Screw: There might be multiple screws, potentially labeled for different speeds (e.g., 33 RPM, 45 RPM). Make sure you are adjusting the correct one for the speed you are currently using or want to affect.
- Make Small Turns: Using a small screwdriver, carefully turn the designated screw.
- Turn Clockwise: According to the provided information, turning the adjustment screw clockwise will cause the platter to rotate faster. Turning counterclockwise will slow it down.
- Check the Speed: Use a strobe disc and light, a speed-checking app, or listen carefully to a known record to verify the new speed.
- Repeat if Necessary: Make small adjustments and re-check until the speed is accurate.
Important Considerations:
- Only make very small adjustments at a time (e.g., a quarter turn).
- Over-tightening or forcing the screws can damage the turntable.
- Not all turntables have user-adjustable speed controls via screws. Some cheaper models or direct-drive turntables might require different methods or have no user adjustment.
This method is specifically for turntables designed with these manual speed calibration points.
