Installing a plastic window well cover helps protect your basement windows from debris, water, and pests. While the specific steps can vary slightly depending on the cover and mounting system, a common method involves securing the cover to the window well using mounting clips.
Here's how you typically install a plastic window well cover, incorporating key steps for installing the mounting clips as described in the reference:
Securing your window well cover often requires installing specific mounting hardware or clips onto the well or the cover itself. The process detailed in the reference focuses on mounting these clips, which is a crucial part of many installations.
Step-by-Step Clip Installation
Based on the provided information, the installation of the mounting clips involves the following actions:
- Prepare the Cover: The process begins by handling the cover, which might involve "removing the cover" from packaging or preparing it for placement and marking.
- Mark and Drill Holes: You will need to drill a specific size hole at designated points. According to the reference, you should "drill a 3/16 inch hole at each marked location." These locations are typically marked on the window well or the cover based on where the clips will attach.
- Mount the Clips: Once the holes are drilled, the mounting clips are attached. You "Mount the clips using the provided cap nuts and bolts." This involves inserting the bolt through the clip and the drilled hole, and then securing it with a cap nut on the other side.
- Adjust Tension: After mounting the clips, they may need adjustment to ensure the cover is held securely but can still be opened. You "tighten the screw Until you reach your desired tension." This screw likely adjusts the grip or pressure the clip applies to the cover or window well lip.
General Installation Context
While the reference focuses on clip installation, a complete window well cover installation typically involves:
- Cleaning the window well area.
- Placing the cover over the well to check for fit and mark mounting locations.
- Drilling holes as needed (like the 3/16 inch holes mentioned for clips).
- Attaching the cover using the installed clips, fasteners, or other included hardware.
- Testing the cover to ensure it is secure yet allows for emergency exit if required.
Ensuring your cover is properly installed using the correct hardware, such as drilling the appropriate 3/16 inch holes and securing with provided cap nuts and bolts as referenced, is essential for its effectiveness and safety.
