Putting a rear windshield wiper back on, especially a new one, typically involves aligning the wiper blade with the arm and securing it. Based on the provided reference for a "Snap Claw Installation" type, a key step involves connecting the blade's cross pin to the arm.
Here's a breakdown of how to put a rear wiper blade back on, focusing on an installation method similar to the reference:
Understanding the Connection
Rear wiper blades attach to the wiper arm using various methods. The reference describes an installation where a "Cross Pin" on the new wiper blade connects to the arm. This is a common attachment type.
Steps for Reattaching a Rear Wiper Blade
Follow these general steps to put your rear wiper blade back on, similar to installing a new one:
- Prepare the Wiper Arm: Gently lift the rear wiper arm away from the glass. Ensure the arm is held securely or locked in an upright position if possible to prevent it from snapping back against the window.
- Align the New Blade: Position the new wiper blade correctly relative to the end of the wiper arm.
- Connect the Pin: As mentioned in the reference, "Position the new wiper blade insert. The Cross Pin on the wiper blade into the center opening on the arm." You will guide the cross pin or similar connector on the blade into the corresponding slot or opening on the end of the wiper arm.
- Secure the Blade: Once the pin is aligned, you usually need to push or slide the blade onto the arm until it clicks or locks into place. This secures the connection.
- Test the Connection: Gently pull on the blade to ensure it is firmly attached to the arm. Lower the arm back onto the rear windshield.
- Check Operation: Before driving, test the wiper function to confirm the blade is attached correctly and wipes smoothly across the glass.
Different wiper blades and arms may have slightly varied connection mechanisms, but the principle of aligning and securing the blade to the arm remains consistent. Always refer to the specific instructions provided with your replacement wiper blade if available.